As for 22 pixels - I didn't mean the LEDs, I mean the Mute/Solo buttons,
but thanks for correcting me.
Yup. This can wait I guess.
2014-01-28 Vesa <[email protected]>
> On 01/28/2014 12:27 PM, Tobiasz Karoń wrote:
> > Instead of additional LEDs I have a little different concept:
> >
> > I could do graphics for such "lamp buttons" that would be the size of
> > current buttons, but would replace them.
> > They could be used just for Solo/Mute buttons both in the Project
> > Editor and Mixer.
> >
> > These could be 22x22 (about - correct me!) graphics. In the Project
> > Editor they'd be side by side, in the Mixer they'd be vertically in
> > one column (Mute on top or Solo on top?).
>
> 22 is way, way too large. The current leds are 15 pixels wide (IIRC) and
> that's about as large as they should be.
>
>
> > I'd just need to know the colors for lit Mute and lit Solo (Mute i
> > guess would be red, and solo - orange?)
> > The off states would be gray.
> >
> > Please note that this concept inverts the mute button state in
> > relation to 0.4.15 - previously it was the "ON" button, now it's the
> > "OFF" button, so inverting this behavior and automation interpreting
> > in older projects might be needed. But this is probably already done
> > since the button is already a mute button - i.e when it's enabled, the
> > sound is disabled - in 0.4.15 when this was enabled, the sound was
> > enabled too.
>
> This is getting so far into new functionality territory, that I don't
> think this is something that we should even consider until after the
> next release is out. Right now we should concentrate on bugfixes and
> polishing the RC for release, not new functionality.
>
> There's all kinds of things to consider here - breaking existing
> workflows, backwards-compatibility (if you load an old track, will all
> the channels be muted?) and so on. This is really not something I'm
> comfortable starting at this stage.
>
> We can start discussions about the mute/solo leds again after 1.0.0 is
> out. For now, I think it's best we stick with the current implementation.
>
--
Tobiasz *unfa*
-----BEGIN GEEK CODE BLOCK-----
Version: 3.1
GIT/MU/P d->-- s+:-(--)> a? C++(+++)>$ ULC+(++)>$ !P? L+++>++++$ E? W++>$
!N-? !o--? K-? !w-- O? !M-- V? PS++ PE++ !Y+ !PGP+? !t(+) 5? !X !R+ tv
b+>+++ DI>+ D+ G e h-->- !r y--()
------END GEEK CODE BLOCK------
------------------------------------------------------------------------------
WatchGuard Dimension instantly turns raw network data into actionable
security intelligence. It gives you real-time visual feedback on key
security issues and trends. Skip the complicated setup - simply import
a virtual appliance and go from zero to informed in seconds.
http://pubads.g.doubleclick.net/gampad/clk?id=123612991&iu=/4140/ostg.clktrk
_______________________________________________
LMMS-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/lmms-devel
