Hello Josiah, Tuesday, June 24, 2003, 10:15:58 PM, you wrote:
>>You cannot burn EPROMS with a NIC because the card does not supply the voltage >>needed for the programming process of the eprom. >> >>flash memory (e.g. AT29C512 or AT29C010) can be programmed onboard of the 3COM >>905b-TX NIC. So you have to prove if flash memory can be used with your NICs, >>in case of any ne2000 cards i guess you can not. > I was afraid that was too good to be true. With the 3cs it isn't burning then, > just programming? I guess I don't really understand the difference. I'd just test the case. I'm quite sure that 29C512 will work with standard NIC. The 29C010 will be too large (128kB) for most NE2000-clones. If you don't mind buying *one* chip for testing... (I had a NIC that explicitely stated supporting both, and it was a PCI NE2000 clone, long time back...) I'm not in the situation to own a NE clone anymore (RTL8139/69 cards), so cannot run this test myself. Best regards, Anselm Martin Hoffmeister Stockholm Projekt Computer-Service <[EMAIL PROTECTED]> ------------------------------------------------------- This SF.Net email is sponsored by: INetU Attention Web Developers & Consultants: Become An INetU Hosting Partner. Refer Dedicated Servers. We Manage Them. You Get 10% Monthly Commission! INetU Dedicated Managed Hosting http://www.inetu.net/partner/index.php _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.freenode.net
