[Completed post here.  There was only a little bit more to
write.  The moral is, Do not reply while tired.]

On Tue, Sep 17, 2024, at 09:14, Brian May via luv-main wrote:
> "Sara Marcondes" <[email protected]> writes:
>> Just to give my 2ยข, I'm going to guess it is something to do with
...
> Also I have a nagging suspicion:
>
> Just before this problem started up, the battery got drained to 0. Not
> sure if this is because the computer didn't go to sleep correctly when I
> thought it had, or if it was because it woke up during sleep. Or maybe
> the computer already encountered this issue and I hadn't notice. But the
> computer wouldn't turn on for a while, and seemed incredible slow to
> start charging (I didn't time it, I probably was slightly on the
> impatient side at the time). Eventually it did charge, and I got it back
> to 100% charge. And that is when I first had the suspend/resume issues.

Just some random thoughts along these lines:

When you were having the original trouble with NVMe errors on
suspend / resume, was that suspend / resume on battery power
or on mains power?  It's conceivable that if the battery got
damaged somehow by the deep discharge, then it might not have
enough juice to bring the machine out of suspend โ€” or even if
you're on mains power, the battery might be drawing enough
current to "brown-out" the system, and the NVMe drive might just
be the most sensitive component.

But if the battery were in bad shape, then you'd be getting much
reduced running time on battery, which you haven't mentioned.

I've had laptops that wouldn't boot even on mains power (from
power brick) with the battery connected, but would boot fine if
I physically disconnected the battery โ€” presumably because the
battery was pulling in too much power trying to recharge.  Maybe
the charging circuitry was broken.  A lot depends on the design
of your particular machine.

Caveats:  Some laptops *require* the battery to be in place, and
bad things can happen if you try to run off the external power
pack without the battery in place.  The Pine64 Pinebook Pro is
one such.  To run it without the battery in place, you have to
connect up a special by-pass cable.  Most laptops will run fine
from external power with the battery disconnected, but it would
be wise to check.  Maybe there's a repair guide for you on
iFixit.com.  And if you are opening up your laptop, take the
usual precautions against static discharge and short-circuits.

What I was going to say is that if it is feasible to disconnect
the battery, you could try to see whether the error happens when
you're running without the battery connected.  Of course, if
you're doing suspend-to-RAM, then you'll need to keep power
supplied while suspended.

But then, from your most recent report, it seems that the
problem has more-or-less gone away.  So the above is maybe just
stuff to keep in mind if it recurs.  Maybe the battery's settled
a bit in time.  Maybe it's a different problem altogether, like
configuration as Sara suggested.  These things can take a lot of
time and work to track down.  [Your favorite trouble-shooting
story goes here. :-)]

One thing I'll add, though:  Most systems will report 100%
relative to what they think is the current battery capacity.
That 100% might be only a fraction of the battery's original
capacity.  I guess a question is whether you're still getting
much the same running time on battery.


โ€” Smiles, Les.
_______________________________________________
luv-main mailing list -- [email protected]
To unsubscribe send an email to [email protected]

Reply via email to