Brian, I appreciate the insights. My first reaction to seeing your new board was that this was a good solution. But after reading through your post, I changed my mind. It's probably still much easier (and cheaper) to buy the FTDI cable designed for CISCO routers, clip off the RJ45 end and then solder on the DB25. Those cables have the proper levels and it's easy enough to solder the DB connector. The only thing I don't like is the flat, light blue, cable.
Kurt On Wed, Jul 17, 2019, at 10:49 AM, Brian K. White wrote: > Kinda sorta maybe possibly. I had thought about using one of the > variants of max232, instead of the 3 transistor hack. But in the end, > the 3 transistors is probably the cheapest and simplest circuit to make > a tpdd work, and this new circuit with the part that Rick Shear > identified, really does seem to be just like the original cable. I > haven't used a scope to compare the actual signals, but I have a scope > and an original cable so I could. I think I'll do that. > > It was a while ago so I might have some of this wrong, but what I think > I remember was most of those ttl to rs232 level-shifter chips don't have > 3 channels, and so you can't handle all 3 lines that the three > transistors handle, you wouldn't get DSR/DTR. And most of them also need > auxiliary caps for the charge pump to parasite power from the rs232 > lines which do not actually deliver any power to speak of. There are > special ones that have their own caps built in, and there are special > ones with more channels, or you could use multiple regular ones. So, you > might only be trading 3 transistors for a max232 and two caps, or a big > expensive special max232 etc. > > I still wouldn't mind tryng it just for the heck of it. The result would > be a cable that should be more technically correct, and so and more > reliable, when used with other random generic serial ports besides the > one on a model 100-200, yet still work perfectly on a model 100-200 > (which has pullup resistors, which the original tpdd cable circuit banks > on). > > But I don't think the result would be any cheaper or simpler to make. > > -- > bkw > > > On 7/17/19 10:59 AM, Kurt McCullum wrote: > > Brian, > > > > I noticed you have a new DB25 PCB on Osh Park. I suspect the whole > > TPDD cable was intended to take a TTL level floppy drive and bring it > > to a standard RS-232 level. I'm wondering if that same PCB could be > > used with one of the inexpensive TTL level FTDI USB to serial > > converters to create a PC to Model-T cable? The only problem I see is > > that the TTL level FTDI cables are all 6 wire and don't seem to have > > the DTR wire. But I suspect that could be hard wired some how. > > > > Kurt > > > > On Wed, Jul 10, 2019, at 11:28 PM, Brian K. White wrote: > >> I finally did the version of this that I had envisioned. > >> https://oshpark.com/shared_projects/Sk27mJwq > >> > > > >
