Re: [Machinekit] Cannot find ethernet ip adress of Beaglebone Black

[schoone...@btinternet.com]

On 12/02/17 14:15, Sag ich Dir nich wrote: I need to know the ip adress of my beaglebone so i can connect it to my pc via ssh but when i write ifconfig in the terminal i get no ethernet ip adress: machinekit@beaglebone:~$ ifconfig eth0      Link encap:Ethernet  HWaddr a0:f6:fd:4b:9c:97             inet6 addr: fe80::a2f6:fdff:fe4b:9c97/64 Scope:Link           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1           RX packets:316 errors:0 dropped:0 overruns:0 frame:0           TX packets:51 errors:0 dropped:0 overruns:0 carrier:0           collisions:0 txqueuelen:1000            RX bytes:77089 (75.2 KiB)  TX bytes:13100 (12.7 KiB)           Interrupt:40  lo        Link encap:Local Loopback             inet addr:127.0.0.1  Mask:255.0.0.0           inet6 addr: ::1/128 Scope:Host           UP LOOPBACK RUNNING  MTU:65536  Metric:1           RX packets:0 errors:0 dropped:0 overruns:0 frame:0           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0           collisions:0 txqueuelen:0            RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) What is usb0?  Is this a USB modem or similar? usb0      Link encap:Ethernet  HWaddr a0:f6:fd:4b:9c:99             inet addr:192.168.7.2  Bcast:192.168.7.3  Mask:255.255.255.252           UP BROADCAST MULTICAST  MTU:1500  Metric:1           RX packets:0 errors:0 dropped:0 overruns:0 frame:0           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0           collisions:0 txqueuelen:1000            RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) You may need to disable ipv6 to get ipv4 ip addresses eg http://raspberrypi.stackexchange.com/questions/23884/force-ipv4-address do i have to install something? -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout. -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.