Thank you, ill try that usb0 is (i believe) the emulated network over usb (so you can communicate with the beaglebone with the ip 192.168.7.2)
Am Sonntag, 12. Februar 2017 16:15:54 UTC+1 schrieb Schooner: > > > On 12/02/17 14:15, Sag ich Dir nich wrote: > > I need to know the ip adress of my beaglebone so i can connect it to my pc > via ssh but when i write ifconfig in the terminal i get no ethernet ip > adress: > > machinekit@beaglebone:~$ ifconfig > eth0 Link encap:Ethernet HWaddr a0:f6:fd:4b:9c:97 > inet6 addr: fe80::a2f6:fdff:fe4b:9c97/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:316 errors:0 dropped:0 overruns:0 frame:0 > TX packets:51 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:77089 (75.2 KiB) TX bytes:13100 (12.7 KiB) > Interrupt:40 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:65536 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > What is usb0? Is this a USB modem or similar? > > usb0 Link encap:Ethernet HWaddr a0:f6:fd:4b:9c:99 > inet addr:192.168.7.2 Bcast:192.168.7.3 Mask:255.255.255.252 > UP BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > > You may need to disable ipv6 to get ipv4 ip addresses > eg > http://raspberrypi.stackexchange.com/questions/23884/force-ipv4-address > > do i have to install something? > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > > > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
