#370: Problem during the boot: "wifi%d: unable to attach hardware: 'Hardware
revision not supported' (HAL status 13)"
-------------------------------------------------------------+--------------
Reporter: [EMAIL PROTECTED] |
Owner:
Type: defect |
Status: new
Priority: major |
Milestone:
Component: madwifi: other |
Version: trunk
Keywords: Hardware revision not supported (HAL status 13) |
Patch_attached: 0
-------------------------------------------------------------+--------------
I got an Acer laptop with (lspci):
0000:00:0b.0 Ethernet controller: Atheros Communications, Inc.: Unknown
device 001a (rev 01)
and kernel linux-2.6.15.1
My problem is that when i boot Gentoo after a Windows session the madwifi
driver works very well
but if i directly boot Gentoo (which is in 99% of case) the modules are
regulary loaded, but i got this from dmesg:
ath_hal: 0.9.16.13 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
RF5413, DFS)
wlan: 0.8.4.2 (svn 1440)
ath_rate_sample: 1.2 (svn 1440)
ath_pci: 0.9.4.5 (svn 1440)
ACPI: PCI Interrupt 0000:00:0b.0[A] -> GSI 17 (level, low) -> IRQ 22
wifi%d: unable to attach hardware: 'Hardware revision not supported' (HAL
status 13)
ACPI: PCI interrupt for device 0000:00:0b.0 disabled
I don't know how to solve this problem
--
Ticket URL: <http://madwifi.org/ticket/370>
MadWifi <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
