Maybe if you turn it upside down it fits a R200?
>List,
>Can the diff experts out there please have a look at this pic of
>Wayne's moustache bar, particularly at the position of the holes
>where the bar mounts to the diff cover. I don't recall ever seeing
>a bar with the holes off centre like shown. Any ideas anyone,
>dodgy bar? Off something other than a Datto? ideas on whether to
>re-use it or get the stock bar? This looks like it would jack to
>diff up and put some unnecessary strain on the rear x member? any
>help appreciated. I've left the series of on & off list posts
>intact if you need to catch up on what's going on.
>
>regards
>Terry
>
>> Hi Terry
>>
>> the images is places at:-
>> http://www.datascribe.com.au/membersozdat/Spring.gif
>>
>> login - ozdatmember
>> password: datsunp510
>>
>
>Terry & Heather wrote:
>
>> Wayne,
>> Your bar is a type 2 from my earlier post (i.e. straight edge
>> top & bottom). The position of the diff mounting holes is what i
>> don't like. You have the bar the correct way up in the drawing
>> and the spacers do go on the top of the diff between the housing
>> and the x member. Everything's OK except those holes.
>>
>> I have sent your drawing to James to put on the Ozdat site as i
>> want some of the others to have a look at it cause it don't seem
>> right to me and i've got lots of those bars but none of them
>> look like that. When James lets me know that the gif can be
>> seen by the list I'll post this reply with a "please help"
>> tacked on and we'll see what responses come in.
>>
>>
>> btw No probs writing direct, no bother what's so ever and you're
>> most welcome to stay in touch. If you need to know something and
>> for whatever reason don't want to go list side, just drop a
>> line.
>>
>> ~later
>> Terry
>>
>> Wayne wrote:
>>
>>> Terry, Thanks for the info on the rear leaf spring, it gave
>>> me a fair idea onits orientation, but I only want to put it in
>>> one more time as it is a slightpain in the butt to get in. I
>>> have attached a basic diagram of how I thinkit goes in. If you
>>> could verify it for me that would be great.Also, where do the
>>> 4 shims that you use with the diff to crossmemberbolts go ?
>>> Above or below the diff. I would think above. My manual
>>> referrsto them, but doesn't say exactly where. Sorry to bother
>>> you on your personal email address, but I wanted to attachthe
>>> diagram and I don't know if I can send it through the
>>> discussion group.Once again, thanks for your help. Maybe
>>> oneday I can repay the favor. -Wayne.
>>
>
>--------------19316A919796A8C50245BDF5
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
