g`day,
i paid $132 for the calipers, im going to be using the stock 3/4"
mastercylinder for a while then probly switch to somthing bigger if the
stocky dont feel too good.
Paddy
----- Original Message -----
From: ryan chalmers <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, October 13, 2000 4:10 AM
Subject: Re: hilux calipers and 200b struts
> I think I will be ringing around the wreckers tomorrow? what did you pay
> for the calipers? and what master cylinder are you going to use the
standard
> one??
> Ryan
>
>
> >
> > Ryan,
> > these had girlock calipers not sumitomo`s, there are two types of
> >girlock
> >caliper one takes the 1091 the other the 1027 pad. the 1027 type is what
i
> >fitted the hilux calipers to.
> > I`d say they would fit the ones you speak of aswell as they use the
same
> >disc going by the DBA catalog. 253mm diameter as opposed to the 244mm
1091
> >type.
> > I`m not sure if the hilux calipers will fit on the 1091 type or not
tho.
> >Paddy
> >
>
> >
> > > Paddy,
> > > Were your old calipers the sort that took the squarish pads (sumitomo
> > > calipers) pads part number db86? As I think I will have to look into
> >these
> > > babies.
> > > Ryan
> > >
> > >
> > > >
> > > > ok i bought the calipers today, and they bolted on to the 200b
> >struts
> > > >and
> > > >fit perfectly over the discs, outer edge of disc just above level
with
> > > >outer
> > > >edge of the pad(0.5-1mm), inside edge of pad slightly further towards
> > > >center
> > > >of disc(~5-10mm) than the 200b pads, had to use the hilux bolts as
the
> >200b
> > > >were a little short on thread, but that was all. damn easy conversion
> >for
> > > >on
> > > >a 200b, havent fitted the struts to me 510 yet but that will be done
> >the
> > > >next few days.
> > > >the calipers were off an 8/81 hilux 4WD, they have 2 small and 2
larger
> > > >pistons
> > > >the struts were off a 79 200b, 253mm discs not the db1091 pad type
> >ones.
> > > >the struts will need to be swaped on the 510, 13" wheels may JUST fit
> > > >depending on the wheel design, my cheviot hotwires fit over them but
> >only
> > > >just by 1-2mm.
> > > >Paddy
> > > >
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
