Hey list,
My FJ turbo is now going into my 510 due to wories about the strength of my
710SSS body shell because it's pillarless. I think shipping a modified
crossmember will be $$$$ so I figure on fabricating everything myself. My
question is... with regard to fabricating the mounts, should I cut the old
mount pedestals off the crossmember before I bolt it back on or can I modify
the existing mounts after I fit it? Also is there any tunnel bashing to be
done? Just saves me lowering the lump in and having to lift it out again
just to get busy with the hammer :-) Hopefully it will be in by next weekend
:-) ...although a way off running as I haven't got the turbo fixed yet :-(
Cheers,
Eddie
England
510, KP710, B10, KB110,
B110, B120, J710, H230,
G620, P330, SRL311, C30,
VBF10, E10, S12
[EMAIL PROTECTED]
pics at www.ratdat.com
New site at www.ratdat.co.uk not finished yet though...
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
