hmm lucky I didn't cut them out then!
There is not a plug on the end of them though, they have individual plugs
that look like factory items.
can I rewire the solenoid wire and bypass those wires?
zac
----- Original Message -----
From: Terry Rudd <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, May 20, 2001 9:16 PM
Subject: RE: mystery wires
> Zac,
>
> I also think it's an auto loom, those wires match. The Aussie auto has a
> reverse relay & switch and engine compartment light switch located on the
> strut tower near where an external voltage reg goes - there is a 6 pin
> connector plug there for it. If you have an auto loom you may have to
> connect a few things up to get the solenoid wire to fire when you turn the
> key to start.
>
> regards
> Terry
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Zac Campbell
> Sent: Sunday, 20 May 2001 9:10
> To: [EMAIL PROTECTED]
> Subject: Re: mystery wires
>
>
> Terry, it is a replacement loom which is stock
> They come out about the drivers side strut tower. I thought it might be an
> auto loom but still nothing there...
> Other possiblity is external alternator regulator.
>
> Everything else lines up fine so I assume it is a 1600 loom!
>
> zac
>
> ----- Original Message -----
> From: Terry Rudd <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Sunday, May 20, 2001 8:28 PM
> Subject: RE: mystery wires
>
>
> > Zac,
> >
> > I have all of the wiring diagrams for every variety of 1600 that was
ever
> > made but I need some more clews, these are on the replacement loom? and
> you
> > don't know what they're for.
> >
> > Where about on the loom - this is going to be hard to describe but as
> close
> > as possible to another component would help.
> >
> > regards,
> >
> > Terry
> >
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of
> > [EMAIL PROTECTED]
> > Sent: Sunday, 20 May 2001 4:29
> > To: [EMAIL PROTECTED]
> > Subject: mystery wires
> >
> >
> > Hey list, I have just about finished fitting the replacement wiring loom
> in
> > but
> > there are 6 (yes 6!) wires that I cannot find on the wiring loom
> > They are two Red/Black and one Black/Red, and two Black/Yellow and one
> that
> > looks black/yellow.
> > I can't find them anywhere on the wiring loom diagram.
> >
> > Any ideas!?
> >
> > zac
> >
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
