----- Original Message -----
Sent: Wednesday, October 03, 2001 11:43
AM
Subject: Re: tuning micotech digi one
fuel only..
hi, there is a air/fuel ratio
meter available in a kit form , from jaycar electronics and also dick
smiths (i think). the design comes from "silicon chip magazine" its a
electronic hobbyist magazine, i reckon that i still have some data some where
for the kit.
it costs about 60-70
dollars for the kit, but has to be calibrated , i think that there is
some calibration that can be done , depending on the characteristics of
the o2 sensor. with out using a proper a/f meter.
but it would pay to get it properly calibrated
at a garage etc...
i think that this would help out alot using this
meter , i will definately be getting one , ( i should be going to adelaide
next week, so i`ll get a kit then)
i am using mercedes injectors( green) , and going by
what the guy said at rpm in adelaide , they are running
at a high (?) rate and might pay to go to higher
flow.
i am getting 114kw at wheels, with a slipping
clutch (new clutch should be here soon). he said if i wind the boost upand
bigger injectors, i should be seeing about 150 kw at wheels.
what sort of injectors would u use to get this
150 kw?
i am tidying up the engine bay at the moment ,
so it would be about a week or so till its finished.
did you read my messages about the head bolt
thread stripped? thats roughly where the water was leaking,, but it titened
down alright in the first place? but what i cant figure iis that yours was
leaking in the same place....
seeya later, mark
Mark,
Hard question to
answer mate as you will really need some sortof an airfuel ratio to get your
mixtures 100%. As for how they work yeah i should be able to answer anything
you need to know. When i upgraded my standard z18 injectors to ca18det ones
i had to cut the MIX trim to -35% just to get it to idle and run. Its a
pretty basicly setup computer thou and i have a manual if you wanna know
anything.
What kindof injectors you gunna use??
Steve.
mark krawczuk wrote:
-----hi, curious to know, does any body out there
know how to tune up the microtech digi one fuel only computer? i was
thinking of putting bigger injectors in it later on, and i dont really
wanna drag it another 500 km (round trip, to adelaide) to get it
done... thanks, mark
krawczuk
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
