Hi there is a air fuel meter made by heltec could HELTUNER that works on aoxegen sensor witch gives you a reading at all times . I have one in my car and it is really good thing to have . I am running a microtec MT8 .RON ----- Original Message ----- From: "James Cox" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, October 03, 2001 2:09 PM Subject: Re: tuning micotech digi one fuel only..
> I was told this kinda setup had to be done under load, eg on a dyno. > > James Cox > > > > >From: "mark krawczuk" <[EMAIL PROTECTED]> > >Reply-To: [EMAIL PROTECTED] > >To: <[EMAIL PROTECTED]> > >Subject: Re: tuning micotech digi one fuel only.. > >Date: Wed, 3 Oct 2001 11:13:42 +0930 > >MIME-Version: 1.0 > >Received: from [209.61.188.254] by hotmail.com (3.2) with ESMTP id > >MHotMailBD84613C002E40043718D13DBCFE124C0; Wed, 03 Oct 2001 06:44:37 -0700 > >Received: from mars (CPE-203-45-12-50.vic.bigpond.net.au [203.45.12.50])by > >jupiter.linuxengine.net (8.11.6/8.11.0) with ESMTP id f93Dsk217156;Wed, 3 > >Oct 2001 08:54:46 -0500 > >From [EMAIL PROTECTED] Wed, 03 Oct 2001 06:45:26 -0700 > >Message-ID: <001401c14bac$d5d8d520$060157cb@w5a9y3> > >X-Priority: 3 > >X-MSMail-Priority: Normal > >X-Mailer: Microsoft Outlook Express 4.72.3110.1 > >X-MimeOLE: Produced By Microsoft MimeOLE V4.72.3110.3 > >X-UIDL: lGA!![[1!!llK!!8PM!! > >Sender: [EMAIL PROTECTED] > > > >hi, there is a air/fuel ratio meter available in a kit form , from jaycar > >electronics and also dick smiths (i think). the design comes from "silicon > >chip magazine" its a electronic hobbyist magazine, i reckon that i still > >have some data some where for the kit. > > > >it costs about 60-70 dollars for the kit, but has to be calibrated , i > >think that there is some calibration that can be done , depending on the > >characteristics of the o2 sensor. with out using a proper a/f meter. > > > > but it would pay to get it properly calibrated at a garage etc... > > i think that this would help out alot using this meter , i will > >definately be getting one , ( i should be going to adelaide next week, so > >i`ll get a kit then) > > i am using mercedes injectors( green) , and going by what the guy said > >at rpm in adelaide , they are running > >at a high (?) rate and might pay to go to higher flow. > > i am getting 114kw at wheels, with a slipping clutch (new clutch should > >be here soon). he said if i wind the boost upand bigger injectors, i should > >be seeing about 150 kw at wheels. > > what sort of injectors would u use to get this 150 kw? > > i am tidying up the engine bay at the moment , so it would be about a > >week or so till its finished. > > did you read my messages about the head bolt thread stripped? thats > >roughly where the water was leaking,, but it titened down alright in the > >first place? but what i cant figure iis that yours was leaking in the same > >place.... > > > > > > seeya later, mark > > -----Original Message----- > > From: steven.taylor <[EMAIL PROTECTED]> > > To: [EMAIL PROTECTED] <[EMAIL PROTECTED]> > > Date: Wednesday, October 03, 2001 8:02 PM > > Subject: Re: tuning micotech digi one fuel only.. > > > > > > Mark, > > Hard question to answer mate as you will really need some sortof an > >airfuel ratio to get your mixtures 100%. As for how they work yeah i should > >be able to answer anything you need to know. When i upgraded my standard > >z18 injectors to ca18det ones i had to cut the MIX trim to -35% just to get > >it to idle and run. Its a pretty basicly setup computer thou and i have a > >manual if you wanna know anything. > > What kindof injectors you gunna use?? > > Steve. > > > > mark krawczuk wrote: > > > > > > -----hi, curious to know, does any body out there know how to > >tune up the microtech digi one fuel only computer? i was thinking of > >putting bigger injectors in it later on, and i dont really wanna drag it > >another 500 km (round trip, to adelaide) to get it done... thanks, > >mark krawczuk > > > > > >--membersozdat------------------------------------------------------- > > OZDAT Mailing List Please Note:- > > Send (un)subscribe requests to [EMAIL PROTECTED] > > Send submissions to [EMAIL PROTECTED] > > No unauthorised redistribution of this email > > http://www.ozdat.com/ozdatonline/index.htm > > http://www.ozdat.com/ozdatonline/listindex.html > > http://www.mail-archive.com/[email protected]/ > > > >--------------------------------------------------------------------- > > > > > --membersozdat------------------------------------------------------- > > OZDAT Mailing List Please Note:- > > Send (un)subscribe requests to [EMAIL PROTECTED] > > Send submissions to [EMAIL PROTECTED] > > No unauthorised redistribution of this email > > http://www.ozdat.com/ozdatonline/index.htm > > http://www.ozdat.com/ozdatonline/listindex.html > > http://www.mail-archive.com/[email protected]/ > --------------------------------------------------------------------- > > > > > _________________________________________________________________ > Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
