Honestly, I just used a small amount of selley's all clear. I'm not sure of the antisqueal stuff!
Cheers Daniel Kroehn ----- Original Message ----- From: "Bob" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Sunday, June 23, 2002 11:58 AM Subject: Re[2]: Brake Squeal > Thanks Mark and Daniel - do you need special silicon to do the job > (for the heat?). That anti-squeal stuff - how do you get the pads out > next time you want to change them?? > > Sunday, June 23, 2002, 12:50:24 AM, you wrote: > > DK> I just use a small amount of silicon on the piston face, usually does the > DK> trick for keeping the pads off the disk when you don't have your foot on the > DK> brake! > > DK> Daniel Kroehn > > DK> ----- Original Message ----- > DK> From: "mark krawczuk" <[EMAIL PROTECTED]> > DK> To: <[EMAIL PROTECTED]> > DK> Sent: Saturday, June 22, 2002 11:05 PM > DK> Subject: Re: Brake Squeal > > > >> hi, there is a anti squeal stuff, it is actually a type off glue that you > >> put on the back of the pad so that it sticks to the caliper piston. the > >> squeal is actually a sorta vibration between the pad and piston. > >> try some supaglue or maybe contact type cement. > >> i have roughened the pads up and that worked for a while. > >> also try putting a few very slight cuts in the pads witha hacksaw. > >> > >> mark k > >> > >> ----- Original Message ----- > >> From: "Bob" <[EMAIL PROTECTED]> > >> To: <[EMAIL PROTECTED]> > >> Sent: Saturday, June 22, 2002 9:51 PM > >> Subject: Brake Squeal > >> > >> > >> > Hello membersozdat, > >> > > >> > I just changed the front pads in the 260z, half cause they werent at > >> > thier best, half cause they were squealing a bit and I was told that > >> > in those brakes they start to squeal when the pads get low. So I > >> > replaced them and they were quiet (and better) initially, but now > >> > 10km later they are squealing worse than the old ones, what could be > >> > causing this? The pads I put in were ferodo excel. Is there meant to > >> > be some kind of anti squeal shim in there? My knowledge of > >> > caliper/pads etc is pretty poor, so sorry if this is an obvious > >> > question. > >> > > >> > -- > >> > Best regards, > >> > Bob mailto:[EMAIL PROTECTED] > >> > > >> > > >> > > > > > -- > Best regards, > Bob mailto:[EMAIL PROTECTED] > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
