Cool, thanks for that. I just wanted to check before I went to do the job and lost use of another finger from ramming my finger into the brake caliper when the bleeding nipple finally decided to undo (man its hard to touch type).
Sunday, June 23, 2002, 12:58:39 PM, you wrote: DK> Honestly, I just used a small amount of selley's all clear. I'm not sure of DK> the antisqueal stuff! DK> Cheers DK> Daniel Kroehn DK> ----- Original Message ----- DK> From: "Bob" <[EMAIL PROTECTED]> DK> To: <[EMAIL PROTECTED]> DK> Sent: Sunday, June 23, 2002 11:58 AM DK> Subject: Re[2]: Brake Squeal >> Thanks Mark and Daniel - do you need special silicon to do the job >> (for the heat?). That anti-squeal stuff - how do you get the pads out >> next time you want to change them?? >> >> Sunday, June 23, 2002, 12:50:24 AM, you wrote: >> >> DK> I just use a small amount of silicon on the piston face, usually does DK> the >> DK> trick for keeping the pads off the disk when you don't have your foot DK> on the >> DK> brake! >> >> DK> Daniel Kroehn >> >> DK> ----- Original Message ----- >> DK> From: "mark krawczuk" <[EMAIL PROTECTED]> >> DK> To: <[EMAIL PROTECTED]> >> DK> Sent: Saturday, June 22, 2002 11:05 PM >> DK> Subject: Re: Brake Squeal >> >> >> >> hi, there is a anti squeal stuff, it is actually a type off glue that DK> you >> >> put on the back of the pad so that it sticks to the caliper piston. the >> >> squeal is actually a sorta vibration between the pad and piston. >> >> try some supaglue or maybe contact type cement. >> >> i have roughened the pads up and that worked for a while. >> >> also try putting a few very slight cuts in the pads witha hacksaw. >> >> >> >> mark k >> >> >> >> ----- Original Message ----- >> >> From: "Bob" <[EMAIL PROTECTED]> >> >> To: <[EMAIL PROTECTED]> >> >> Sent: Saturday, June 22, 2002 9:51 PM >> >> Subject: Brake Squeal >> >> >> >> >> >> > Hello membersozdat, >> >> > >> >> > I just changed the front pads in the 260z, half cause they werent DK> at >> >> > thier best, half cause they were squealing a bit and I was told DK> that >> >> > in those brakes they start to squeal when the pads get low. So I >> >> > replaced them and they were quiet (and better) initially, but now >> >> > 10km later they are squealing worse than the old ones, what could DK> be >> >> > causing this? The pads I put in were ferodo excel. Is there meant DK> to >> >> > be some kind of anti squeal shim in there? My knowledge of >> >> > caliper/pads etc is pretty poor, so sorry if this is an obvious >> >> > question. >> >> > >> >> > -- >> >> > Best regards, >> >> > Bob mailto:[EMAIL PROTECTED] >> >> > >> >> > >> >> >> >> >> >> >> -- >> Best regards, >> Bob mailto:[EMAIL PROTECTED] >> -- Best regards, Bob mailto:[EMAIL PROTECTED] --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
