Ok that put my mind to rest a bit, I had visions of never being able to get them out. I guess that would be a good incentive for a brake upgrade though..
Sunday, June 23, 2002, 1:04:25 PM, you wrote: mk> hi, u have to use a oxy torch, sledge hammer and a giraffe............no mk> sorry, wrong list......................... u should be able to get the pads mk> of with a bit of pressure by hand , or tap a little with a hammer. mk> mark k mk> ----- Original Message ----- mk> From: "Bob" <[EMAIL PROTECTED]> mk> To: <[EMAIL PROTECTED]> mk> Sent: Sunday, June 23, 2002 11:28 AM mk> Subject: Re[2]: Brake Squeal >> Thanks Mark and Daniel - do you need special silicon to do the job >> (for the heat?). That anti-squeal stuff - how do you get the pads out >> next time you want to change them?? >> >> Sunday, June 23, 2002, 12:50:24 AM, you wrote: >> >> DK> I just use a small amount of silicon on the piston face, usually does mk> the >> DK> trick for keeping the pads off the disk when you don't have your foot mk> on the >> DK> brake! >> >> DK> Daniel Kroehn >> >> DK> ----- Original Message ----- >> DK> From: "mark krawczuk" <[EMAIL PROTECTED]> >> DK> To: <[EMAIL PROTECTED]> >> DK> Sent: Saturday, June 22, 2002 11:05 PM >> DK> Subject: Re: Brake Squeal >> >> >> >> hi, there is a anti squeal stuff, it is actually a type off glue that mk> you >> >> put on the back of the pad so that it sticks to the caliper piston. the >> >> squeal is actually a sorta vibration between the pad and piston. >> >> try some supaglue or maybe contact type cement. >> >> i have roughened the pads up and that worked for a while. >> >> also try putting a few very slight cuts in the pads witha hacksaw. >> >> >> >> mark k >> >> >> >> ----- Original Message ----- >> >> From: "Bob" <[EMAIL PROTECTED]> >> >> To: <[EMAIL PROTECTED]> >> >> Sent: Saturday, June 22, 2002 9:51 PM >> >> Subject: Brake Squeal >> >> >> >> >> >> > Hello membersozdat, >> >> > >> >> > I just changed the front pads in the 260z, half cause they werent mk> at >> >> > thier best, half cause they were squealing a bit and I was told mk> that >> >> > in those brakes they start to squeal when the pads get low. So I >> >> > replaced them and they were quiet (and better) initially, but now >> >> > 10km later they are squealing worse than the old ones, what could mk> be >> >> > causing this? The pads I put in were ferodo excel. Is there meant mk> to >> >> > be some kind of anti squeal shim in there? My knowledge of >> >> > caliper/pads etc is pretty poor, so sorry if this is an obvious >> >> > question. >> >> > >> >> > -- >> >> > Best regards, >> >> > Bob mailto:[EMAIL PROTECTED] >> >> > >> >> > >> >> >> >> >> >> >> -- >> Best regards, >> Bob mailto:[EMAIL PROTECTED] >> >> -- Best regards, Bob mailto:[EMAIL PROTECTED] --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
