I've done it with a 14mm headed bolt but forgo the nuts they will back off
under the torque required to break the plugs loose. I found a good ole
pipe wrench works the best for removal. Then use the nuts on the bolt with
a socket to tighten the plug back up.
John Berryman wrote:
On Monday, January 30, 2006, at 04:49 PM, Kevin wrote:
And you can make one using a metric bolt and a couple of nuts if nobody
around you sells a 14mm allen for what you want to pay for it.
And good luck using that for this application. The fill plugs usually
require a big effort to break loose.
I Mac Therefore I am
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]
To Unsubscribe or change delivery options go to: