[mfg-smartcam] engraving

[mark glassford]

this may seem like a dumb question from someone whos been using s-c for a long time but here goes.we do a lot of engraving and once in a while i will have to bring the z up to clear a bolt or clamp.i would always set the clear for this tool at 1 inch or more only when i had something to clear otherwise i would leave it at .05.this makes for some wasted movement because the tool is always going up an inch or more.what is the proper way to leave the clear at .05 and just jump up to clear the obstruction?

thanks
mark
79 cherokee chief
(above the law)

_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.

Share information about yourself, create your own public profile at http://profiles.msn.com.

======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================