I have RA1's on my Track car. I haven't noticed any wheel bearing-like
noises with them, but I don't drive it on the street that often. They do
tend to flat spot a bit when it sits for a long time, but that noise is not
quite the "woo-woo-woo" sound. Toyo recommends 2.5 degrees of camber to
avoid feathering. But that is almost impossible to achieve in a street
driven Miata that isn't insanely lowered. So maybe it is the tires.

The old Falken Azenis RT-215 definitely had a problem with wheel bearing
like noises. Mine got quite noisy and had me convinced I needed wheel
bearings. Fortunately, someone else told me otherwise before I bought new
wheel bearings. It would seem plausible that the current Azenis tires have
the same issue.

Luis


-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Ian McCloghrie
Sent: Wednesday, October 22, 2008 10:23 PM
To: [email protected]
Subject: replacing wheel bearings


My Miata (it's a 99) has been making a "woo-woo-woo" sound when cruising
-- initially I thought it might be flatspotted tires, but it does it
with both sets of tires, and while I wouldn't be surprised if my RA1s
had flatspots from autocrossing, I don't think I've locked up the Azenis
since they're just street tires.

I swapped the tranny and diff fluid, not really expecting that to be
the cause, but it needed doing anyway.  They both had relatively small
amounts of metal bits in them, but nothing big.  It didn't change the
noise.

So now I'm suspecting the wheel bearings.  Since the car is 10 years
old and has 80K miles, 50+ track days, and 20+ autocrosses on it, I'm
thinking maybe it's time to just do all of them.

The fronts are pretty simple, right?  Integral with the front hubs?

The rears look moderately complex?  Do you need a press to get the
races in/out?  If so, I may have a shop do them.  What parts do I need
to replace when doing it?  The parts diagram shows an oil seal on the
inside -- does that get replaced when doing the bearings?

I've lost a few threads' worth of lugnut engagement due to the Goodwin
BBKs (the aluminum rotor hat is about 5mm thicker than the OEM rotor).
Is there an easy way to get slightly longer studs?

--Ian
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to