I just did a left rear, rumble with the top up, shake test had zero slop in
any axis.. was bad, tho.  Replaced and noise went away, car also tended to
track lane crowns worse as the wheel would toe in/out as it interacted with
the crown.  That has lessened with the new bearing.

You either need a press or a gear puller.  I found this writeup very
helpful (and I had to use my oxy/acet torch to get the bearing race to
move).

http://forum.miata.net/vb/showpost.php?p=1361125&postcount=14
http://forum.miata.net/vb/showpost.php?p=1361129&postcount=15

There was a secondary writeup that had pictures that helped a ton.. This is
how I did it, and it worked fine (with the torch, race wouldn't move
without it)

http://my.att.net/p/s/community.dll?ep=87&subpageid=222341&ck=

You may also need the snap ring.

Longer studs, I believe corvette ones work, but I don't rememebr more
specifics.

Wallyman




                                                                       
             Ashraf Farrag                                             
             <[EMAIL PROTECTED]                                   
             rg>                                                        To
             Sent by:                        Luis <[EMAIL PROTECTED]>
             [EMAIL PROTECTED]                                    cc
             apower.net                      [email protected] 
                                                                   Subject
                                             Re: replacing wheel bearings
             10/23/2008 12:05 AM                                       
                                                                       
                                                                       
                Please respond to                                      
             [EMAIL PROTECTED]                                   
                        g                                              
                                                                       
                                                                       
                                                                       





> So now I'm suspecting the wheel bearings.  Since the car is 10 years
> old and has 80K miles, 50+ track days, and 20+ autocrosses on it, I'm
> thinking maybe it's time to just do all of them.
>
Wheel bearings make a "rumbling" noise as it has been
described/characterized to me.

Shake/wobble test?  Lift car, grab wheel at top and bottom and try to
wiggle and feel for play in the bearing.  If there is play, you'll feel
it and it will sort of "click" but you should also make sure it isn't a
worn suspension joint.  The FSM outlines a more precise test involving a
dial indicator gauge.  Kind of expensive to replace all four if not
needed, IMHO but not a bad idea if the car is a track car.  If you even
suspect wheel bearings, you should not be driving it.

Half-shafts and driveaxle checked?

--Ashraf
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

<<inline: graycol.gif>>

<<inline: pic26031.gif>>

<<inline: ecblank.gif>>

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to