or for the fronts you can just replace the whole hub correct? 
 
To test you don't need to jack it up, we always give a good hard pull in a 
couple axis' at autox safety tests and you can tell a bad one - compare yours 
to another miata or two. 
 
 
*on a side note, I saw where one of the track guys, oh it was Emilio, 
recommended always replacing the hubs in pairs, i.e. "if you do one side, do 
the other as well". Any idea why? I replaced one of my fronts last year, but 
not the other.
 
Ross Kuhns  



Subject: Re: replacing wheel bearingsTo: [EMAIL PROTECTED]: [EMAIL PROTECTED]: 
Thu, 23 Oct 2008 08:52:29 -0400CC: [EMAIL PROTECTED]; [EMAIL PROTECTED]; 
[email protected]
I just did a left rear, rumble with the top up, shake test had zero slop in any 
axis.. was bad, tho. Replaced and noise went away, car also tended to track 
lane crowns worse as the wheel would toe in/out as it interacted with the 
crown. That has lessened with the new bearing.You either need a press or a gear 
puller. I found this writeup very helpful (and I had to use my oxy/acet torch 
to get the bearing race to move). 
http://forum.miata.net/vb/showpost.php?p=1361125&postcount=14http://forum.miata.net/vb/showpost.php?p=1361129&postcount=15There
 was a secondary writeup that had pictures that helped a ton.. This is how I 
did it, and it worked fine (with the torch, race wouldn't move without 
it)http://my.att.net/p/s/community.dll?ep=87&subpageid=222341&ck=You may also 
need the snap ring.Longer studs, I believe corvette ones work, but I don't 
rememebr more specifics.WallymanAshraf Farrag <[EMAIL PROTECTED]>







Ashraf Farrag <[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] 
10/23/2008 12:05 AM 




Please respond [EMAIL PROTECTED]





To
Luis <[EMAIL PROTECTED]>


cc
[email protected]


Subject
Re: replacing wheel bearings




> So now I'm suspecting the wheel bearings.  Since the car is 10 years> old and 
> has 80K miles, 50+ track days, and 20+ autocrosses on it, I'm> thinking maybe 
> it's time to just do all of them.>   Wheel bearings make a "rumbling" noise 
> as it has been described/characterized to me.Shake/wobble test?  Lift car, 
> grab wheel at top and bottom and try to wiggle and feel for play in the 
> bearing.  If there is play, you'll feel it and it will sort of "click" but 
> you should also make sure it isn't a worn suspension joint.  The FSM outlines 
> a more precise test involving a dial indicator gauge.  Kind of expensive to 
> replace all four if not needed, IMHO but not a bad idea if the car is a track 
> car.  If you even suspect wheel bearings, you should not be driving 
> it.Half-shafts and driveaxle 
> checked?--Ashraf_______________________________________________Miatapower 
> mailing [EMAIL 
> PROTECTED]://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

<<attachment: graycol.gif>>

<<attachment: pic26031.gif>>

<<attachment: ecblank.gif>>

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to