On 1/10/12 8:26 PM, Thomas Kreschollek wrote:
I tried the circuit with the following values: R4=R3=22k ohm and
R1=R2=220k ohm  Q1=MPSA42 and Q2=MPSA92 HV= 180 VDC TP1=5 VDC

Only half of it worked (one electrode lights).  If I only use MPSA42
that part of the circuit works fine (made a test circuit with only the
NE-2, a transistor and the required resistors).  If I replace put the
MPSA92 in, the NE-2 stays on, no matter if the 0V or 5V is applied to
the base.  I've tried 2 MPSA92's fresh from the package and still no
luck.  What am I missing?


MPSA92, being PNP, gets wired differently from the schematic that you showed us.

See this schematic, substituting MPSA92 for ZTX558 and MPSA42 for ZTX458:

http://www.cathodecorner.com/nc620akitman.pdf

--
David Forbes, Tucson AZ

--
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to