If you only have a little rust, I would opt for cleaning the tank as best you can and then keeping the tank as full as you can because it will not rust if it not exposed to air. This has worked for me for several years on a 1971 tank. Also add some inline fuel filters. Wynn
On Fri, Jun 18, 2010 at 9:38 AM, Bassam Khalil <[email protected]>wrote: > Thanks again for the helpful advise... > > B-man > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Kyle Munz > Sent: Friday, June 18, 2010 11:14 AM > To: [email protected] > Subject: Re: [Nighthawk Lovers] Re: 85 Nighthawk 650 > > I used POR15 on mine. There are others that people have used but I > can't remember the names. A search of the archives would probably pull > it up. Some swear by them, others think it will fall off the tank and > gum up the line. There are also products that claim to "eat the rust". > If you only have a little you might go that way. > > On 6/18/10, Bassam Khalil <[email protected]> wrote: > > It does have some rust but not much. What is the coating you speak of? > > > > Thanks > > > > B-man > > > > -----Original Message----- > > From: [email protected] > > [mailto:[email protected]] On Behalf Of Kyle Munz > > Sent: Friday, June 18, 2010 11:07 AM > > To: [email protected] > > Subject: Re: [Nighthawk Lovers] Re: 85 Nighthawk 650 > > > > On 6/18/10, Kyle Munz <[email protected]> wrote: > >> I would take it off since it's relatively easy to do. Cleaning it > >> isn't hard. The trick is drying it out thoroughly so any left over gas > >> doesn't ignite.. I used a hair dryer for this, warm dry air evaporated > >> all of the gas. There's some debate about whether or not to coat the > >> inside of the tank. If it's not rusted you may not need to. If it is > >> rusted make sure you clean it thoroughly and do a good job. Make sure > >> the coating sticks. > >> > >> On 6/18/10, Bassam Khalil <[email protected]> wrote: > >>> Should I take of the Gas tank or leave it on? Also should I clean the > gas > >>> tank and if so what should I clean > >>> it with. > >>> > >>> Thanks > >>> > >>> B-Man > >>> > >>> -----Original Message----- > >>> From: [email protected] > >>> [mailto:[email protected]] On Behalf Of surfswab > >>> Sent: Thursday, June 17, 2010 4:25 PM > >>> To: Nighthawk Motorcycle Lovers! > >>> Subject: [Nighthawk Lovers] Re: 85 Nighthawk 650 > >>> > >>> Here's a tip that may save you some grief later: > >>> > >>> There's an o-ring and a nylon filter "sleeve" that fits down over the > >>> brass tube and seats down in the body of the petcock. It's a press > >>> fit kind of an assembly and is held in place by the same large nut > >>> that holds the petcock to the tank. > >>> > >>> Make sure that's in place before you insert the tube into the tank > >>> fitting, then push the whole assembly up into the tank with your > >>> thumbs (fitting looks like a piece of threaded pipe). > >>> > >>> Also make sure the petcock is square to the tank and facing you when > >>> you do this, so it doesn't require twisting the assembly back and > >>> forth to get it aligned properly, after you've started snugging the > >>> big nut. > >>> > >>> If you have to twist the petcock back and forth to align it, you risk > >>> tearing, shredding or twisting the nylon filter, like the previous > >>> owner did to mine (!) > >>> > >>> > >>> -- > >>> You received this message because you are subscribed to the Google > Groups > >>> "Nighthawk Motorcycle Lovers!" group. > >>> To post to this group, send email to [email protected] > . > >>> To unsubscribe from this group, send email to > >>> [email protected]<nighthawk_lovers%[email protected]> > . > >>> For more options, visit this group at > >>> http://groups.google.com/group/nighthawk_lovers?hl=en. > >>> > >>> -- > >>> You received this message because you are subscribed to the Google > Groups > >>> "Nighthawk Motorcycle Lovers!" group. > >>> To post to this group, send email to [email protected] > . > >>> To unsubscribe from this group, send email to > >>> [email protected]<nighthawk_lovers%[email protected]> > . > >>> For more options, visit this group at > >>> http://groups.google.com/group/nighthawk_lovers?hl=en. > >>> > >>> > >> > >> > >> -- > >> > >> -Kyle > >> > > > > > > -- > > > > -Kyle > > > > -- > > You received this message because you are subscribed to the Google Groups > > "Nighthawk Motorcycle Lovers!" group. > > To post to this group, send email to [email protected]. > > To unsubscribe from this group, send email to > > [email protected]<nighthawk_lovers%[email protected]> > . > > For more options, visit this group at > > http://groups.google.com/group/nighthawk_lovers?hl=en. > > > > -- > > You received this message because you are subscribed to the Google Groups > > "Nighthawk Motorcycle Lovers!" group. > > To post to this group, send email to [email protected]. > > To unsubscribe from this group, send email to > > [email protected]<nighthawk_lovers%[email protected]> > . > > For more options, visit this group at > > http://groups.google.com/group/nighthawk_lovers?hl=en. > > > > > > > -- > > -Kyle > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]<nighthawk_lovers%[email protected]> > . > For more options, visit this group at > http://groups.google.com/group/nighthawk_lovers?hl=en. > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]<nighthawk_lovers%[email protected]> > . > For more options, visit this group at > http://groups.google.com/group/nighthawk_lovers?hl=en. > > -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en.
