swejis wrote: > Hello everyone. I'm not very experienced with iscsi, so please excuse > me if asking stupid questions. > > I'm evaluation opensuse 11 (Beta1) for my servers and have found some > worrying errors in the log. The following error quite frequently shows > up. > > May 5 21:15:05 manjula klogd: connection1:0: ping timeout of 5 secs > expired, last rx 4626267449, last ping 4626264949, now 4626269949 > May 5 21:15:05 manjula klogd: connection1:0: detected conn error > (1011) > May 5 21:15:05 manjula iscsid: Kernel reported iSCSI connection 1:0 > error (1011) state (3) > May 5 21:15:09 manjula iscsid: connection1:0 is operational after > recovery (1 attempts) > > The target is the infamous Promise m500i and the initiator "transport > class version 2.0-869. iscsid version 2.0-868" > Nic : Broadcom NetXtreme BCM5721 Gigabit Ethernet PCI Express (tg3) > Kernel 2.6.25-rc9-17-default x86_64 > > There is really no load on this system yet. I used a sniffer to record > the traffic and it seem the target "all the sudden" sends a reset > (frame 65). I'm not sure if this happens at the same time as the error > printed to the log. I have uploaded the capture file here: > http://www.wehay.com/iscsi.cap.gz > > To my first stupid question. The target is equipped with 2 x 1GB nics > having address 192.168.43.5 & 6. When I did the discovery I only > pointed to one of these addresses still both where found and used > (magic). Also I noticed that every lun is registered twice (sdc & d > for lun1 etc), is the reason for this performance, fail over or > perhaps both ? I've spotted in the target the following setting "Max > Connections 1" (non-configurable) and was thinking perhaps this reset > was related to this. I have left all configuration to it's defaults > only changing the login information. > > Config file: http://www.wehay.com/iscsid.conf >
Could you also do cat /sys/class/iscsi_connection/connection1:0/recv_tmo cat /sys/class/iscsi_connection/connection1:0/ping_tmo and send those values. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "open-iscsi" group. To post to this group, send email to open-iscsi@googlegroups.com To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/open-iscsi -~----------~----~----~----~------~----~------~--~---