On Tuesday 26 August 2008 08.34:16 you wrote: > On Mon, Aug 25, 2008 at 11:00 PM, Valentin Longchamp > > <[EMAIL PROTECTED]> wrote: > > > > Here is what I get when I issue the reset halt command through telnet: > > > > [EMAIL PROTECTED]:~/openocd/trunk/src$ ./openocd -f > > target/target/mx31.cfg -f target/interface/jtagkey.cfg > > I would have expected you to use configure interface first.. > > > ./openocd -f target/interface/jtagkey.cfg -f target/target/mx31.cfg > > > I have noticed that the iMX31 is *VERY* sensitive on the precise > implementation of the JTAG interface.
I have tried it with the command ordering you proposed above and I have experienced the same results as before. > > It didn't work w/the parport when we tried it. > > On our ZY1000 reset halt works though(which uses OpenOCD): > > http://www.zylin.com/zy1000.html > > I'm not convinced that the iMX31 will work without RCLK.... OK. I have noticed working with RealView ICE that mx31ads board JTAG chain is not optimal. Do you work with an ADS board Øyvind ? I will try on our board, but I only have one available at work, and I usually work on openOCD at home. Do you know if JTAGkey supports RTCK (we have it wired on our design) ? Regards Valentin _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
