On Tue, Aug 26, 2008 at 12:09 PM, Valentin Longchamp <[EMAIL PROTECTED]> wrote: > On Tuesday 26 August 2008 08.34:16 you wrote: >> On Mon, Aug 25, 2008 at 11:00 PM, Valentin Longchamp >> >> <[EMAIL PROTECTED]> wrote: >> > >> > Here is what I get when I issue the reset halt command through telnet: >> > >> > [EMAIL PROTECTED]:~/openocd/trunk/src$ ./openocd -f >> > target/target/mx31.cfg -f target/interface/jtagkey.cfg >> >> I would have expected you to use configure interface first.. >> >> >> ./openocd -f target/interface/jtagkey.cfg -f target/target/mx31.cfg >> >> >> I have noticed that the iMX31 is *VERY* sensitive on the precise >> implementation of the JTAG interface. > > I have tried it with the command ordering you proposed above and I have > experienced the same results as before. > >> >> It didn't work w/the parport when we tried it. >> >> On our ZY1000 reset halt works though(which uses OpenOCD): >> >> http://www.zylin.com/zy1000.html >> >> I'm not convinced that the iMX31 will work without RCLK.... > > OK. I have noticed working with RealView ICE that mx31ads board JTAG chain is > not optimal. Do you work with an ADS board Øyvind ? I will try on our board, > but I only have one available at work, and I usually work on openOCD at home.
What's an ADS board? > Do you know if JTAGkey supports RTCK (we have it wired on our design) ? nope. -- Øyvind Harboe http://www.zylin.com/zy1000.html ARM7 ARM9 XScale Cortex JTAG debugger and flash programmer _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
