It doesn't seem to be doing anything. And when I run the debugger it brings
up the "Failed to connect to remote" error everytime. Is there some special
place i have to enter this?
"Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message
news:14957@palm-dev-forum...
>
> In Codewarrior, you just plop the Palm in the cradle, enable debugging,
> enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to start the
> debugger. Note...have a paper clip handy...you're going to be doing
> some resetting. You also have to be somewhat persistant sometimes, as
> the serial connection occasionally gets a little fuddled if you do
> something in the wrong order, so you may have to reset your Palm and
> try debugging again.
>
> -Rus
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
