Hello Sam,
You should also make sure that HotSync is off (meaning also that it is not
running in the background), make sure the serial port is free (no
ActiveSync, CE Services, etc.), make sure the debugger Palm Connection
Settings are pointing to the correct COM port, and check that 'shortcut dot
dot 2' is actually 'shortcut tap tap 2' - this means it appears as 'shortcut
. 2' on the device. A good way to check that the device is ready is to enter
it on the Find dialog - if entered right, the whole line will disappear, and
there should not be an up-arrow at the lower right.
Also, in some instances, the device serial port may be busy. A soft-reset
(insert paper clip) will usually clear this up.
Hope this helps.
Rgds,
Jun-Kiat Lam
Metrowerks Technical Support
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Sam
Trimble
Sent: Wednesday, June 21, 2000 4:47 PM
To: Palm Developer Forum
Subject: Re: Debugging w/ Palm
It doesn't seem to be doing anything. And when I run the debugger it brings
up the "Failed to connect to remote" error everytime. Is there some special
place i have to enter this?
"Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message
news:14957@palm-dev-forum...
>
> In Codewarrior, you just plop the Palm in the cradle, enable debugging,
> enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to start the
> debugger. Note...have a paper clip handy...you're going to be doing
> some resetting. You also have to be somewhat persistant sometimes, as
> the serial connection occasionally gets a little fuddled if you do
> something in the wrong order, so you may have to reset your Palm and
> try debugging again.
>
> -Rus
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
