Did you disable Hotsync? Hotsync sits on that port that CW wants
to debug to...
-Rus
>-----Original Message-----
>From: Sam Trimble [mailto:[EMAIL PROTECTED]]
>Sent: Wednesday, June 21, 2000 2:47 PM
>To: Palm Developer Forum
>Subject: Re: Debugging w/ Palm
>
>
>It doesn't seem to be doing anything. And when I run the
>debugger it brings
>up the "Failed to connect to remote" error everytime. Is there
>some special
>place i have to enter this?
>
>"Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message
>news:14957@palm-dev-forum...
>>
>> In Codewarrior, you just plop the Palm in the cradle, enable
>debugging,
>> enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to
>start the
>> debugger. Note...have a paper clip handy...you're going to be doing
>> some resetting. You also have to be somewhat persistant
>sometimes, as
>> the serial connection occasionally gets a little fuddled if you do
>> something in the wrong order, so you may have to reset your Palm and
>> try debugging again.
>>
>> -Rus
>
>
>
>--
>For information on using the Palm Developer Forums, or to
>unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/
>
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
