First of all, your IDE must be configured in the Edit Preferences to
connect to the Palm Device in the Debugger Section, the Target and the
Serial port it'd be using.
Next the shortcut dot dot 2 is entered in the grafiti area, just before
you can download the application.
Germ�n
"Sam Trimble" <[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED]
21/06/00 15:46
Please respond to "Palm Developer Forum"
To: "Palm Developer Forum" <[EMAIL PROTECTED]>
cc:
Subject: Re: Debugging w/ Palm
It doesn't seem to be doing anything. And when I run the debugger it
brings
up the "Failed to connect to remote" error everytime. Is there some
special
place i have to enter this?
"Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message
news:14957@palm-dev-forum...
>
> In Codewarrior, you just plop the Palm in the cradle, enable debugging,
> enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to start the
> debugger. Note...have a paper clip handy...you're going to be doing
> some resetting. You also have to be somewhat persistant sometimes, as
> the serial connection occasionally gets a little fuddled if you do
> something in the wrong order, so you may have to reset your Palm and
> try debugging again.
>
> -Rus
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
