You have to kill hotsync, it's got the serial port when it's running.
--
-Richard M. Hartman
[EMAIL PROTECTED]
186,000 mi/sec: not just a good idea, it's the LAW!
Sam Trimble wrote in message <14962@palm-dev-forum>...
>
>It doesn't seem to be doing anything. And when I run the debugger it brings
>up the "Failed to connect to remote" error everytime. Is there some special
>place i have to enter this?
>
>"Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message
>news:14957@palm-dev-forum...
>>
>> In Codewarrior, you just plop the Palm in the cradle, enable debugging,
>> enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to start the
>> debugger. Note...have a paper clip handy...you're going to be doing
>> some resetting. You also have to be somewhat persistant sometimes, as
>> the serial connection occasionally gets a little fuddled if you do
>> something in the wrong order, so you may have to reset your Palm and
>> try debugging again.
>>
>> -Rus
>
>
>
>
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
