Andrew W. Hill <[EMAIL PROTECTED]> writes: > >My system: >PowerMac 9500 w/ 275MHz G3 ZIF in an XLR8 carrier >64MB RAM >1gig hard disk >Twin Turbo graphics card >MacOS 9.1 > >I installed an FWB PCI Jackhammer UltraWide card and a 10krpm 18gig >IBM U2W drive. The drive does not mount at startup, but I can manual >mount it with Hard Disk Setup. I can install an OS on it, but it >isnt recognized at startup and wont boot from it. > >Suggestions?
Andrew- I think you may be out of luck. I have a PCI Jackhammer SCSI card also and it seems they're not supported beyond Mac OS 9.02. Hammer Storage was bought out by Bell Microproducts. Check out their FAQ on this page: <URL:http://www.rorke.com/hammer/> -Jeff [EMAIL PROTECTED] -- "You can't brew a premium lager with a kool-aid mentality." --Harold Green in _The_Red_Green_Show_ -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Macintosh? Get free email and more at Applelinks! <http://www.applelinks.com>
