thanks i will examine those dimensions
ds
_______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com
Indrek Rebane wrote:
Hi Dennis,
Dennis Saputelli wrote:
for your .8mm BGA what trace line width and air gap do you use?
~0.1mm trace for signals, 0.2mm trace for power pins. Most of the signal lines get impedance matched. Depends on design requirements and stack-up. Minimum clearance is usually 0.1mm, again depends on design.
what ball pad size?
Have different components, from 0.3mm (+/- 0.05mm) to 0.5mm (+/- 0.05mm) ball sizes. Pad is derived from there, according to upcoming IPC-7351 standard.
what via dia and via hole ?
0.25mm hole and 0.45mm capture pad in dense places, larger holes/pads everywhere else.
Indrek
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[EMAIL PROTECTED]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED]
