Configuring a new Ubiquity EdgeRouter-X I'm missing a step between connecting to the unconfigured router on its default IP address and connecting to it on the LAN address.
Connecting the laptop to the router on the 192.168.1.0 network I upgraded the firmware to the newly-released version 1.10, then restored the saved config file from the old router. Then I rebooted the router, but it did not want to complete; I don't know what I did incorrectly up to this point. Resetting the network from 192.168.1.0 to 192.168.55.0 and restarting the laptop after moving the cat5 cable from eth0 on the router to eth1, I tried to connect to it. This failed as the 'network is unreachable.' Sure enough, there are no routes to the network or a default gateway. I could do a hard reset on the router to default configuration and start over upgrading the firmware OS and restoring the saved config file, but I need to learn what step I missed between the configuration on the default network and connecting to the local LAN network address. A pointer or two will be very helpful. Regards, Rich _______________________________________________ PLUG mailing list PLUG@pdxlinux.org http://lists.pdxlinux.org/mailman/listinfo/plug
