Mark,
Most fabricators work to a max of 24" by 32" for printed flex cable. You
can pull some tricks within that frame to increase the maximum length
through folding. If you're using a roll formed type collated flex to get
your length then I would suggest building separate pwbs within protel
(with a common part to definr the interface) and then marry the gerbers
in a viewer.
jmc
Mark E Witherite wrote:
>
> Hi Everyone
> I've been assigned to design a simple flex circuit. The problem is it will
> be 110 X 3.75 inches long. Is there a way to work around the
> 100 X 100 inch maximum work area? Any suggestions would be greatly
> appreciated.
> Cheers
>
> Mark Witherite
> Sr Research Technologist
> Astronomy & Astrophysics
> Penn State University
> 2565 Park Center Blvd
> Suite 200
> State College, PA. 16801
> email [EMAIL PROTECTED]
> telephone 814 865 9839
> fax 814 865 9100
> IPC PWB Certified
>
--
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>John M. Cardone Electro-Mechanical Dsgn. Engr. Grp.
>M/S 278-100 Mechanical Engineering Section, 352
>4800 Oak Grove Dr. NASA / Jet Propulsion Laboratory
>Pasadena, Ca 91109
>Tel: 818.354.5407 MailTo:[EMAIL PROTECTED]
>Fax: 818.393.4860
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
