>
> Hi Everyone
> I've been assigned to design a simple flex circuit. The problem is it
> will
> be 110 X 3.75 inches long. Is there a way to work around the
> 100 X 100 inch maximum work area? Any suggestions would be greatly
> appreciated.

How about making the board at 45 degrees, then it will fit within the
100" square.

Is there really a shop that can make a 110" long board?

Jon


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to