Just a thought, but could you scale all the footprints 1:2 and use 1/2 size
traces.  Then ask your board shop to plot 2:1?

-----Original Message-----
From: Mark E Witherite [mailto:[EMAIL PROTECTED]]
Sent: Monday, April 02, 2001 11:29 AM
To: Protel EDA Forum
Subject: [PEDA] need a work around for the 100 sq in restriction


Hi Everyone
I've been assigned to design a simple flex circuit. The problem is it
will
be 110 X 3.75 inches long. Is there a way to work around the
100 X 100 inch maximum work area? Any suggestions would be greatly
appreciated.
Cheers







Mark Witherite
Sr Research Technologist
Astronomy & Astrophysics
Penn State University
2565 Park Center Blvd
Suite 200
State College, PA.  16801
email [EMAIL PROTECTED]
telephone 814 865 9839
fax           814 865 9100
IPC PWB  Certified



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to