I had this trouble, about a week ago, where the colour of the solder
resist is always the same as the top/bottom layer, no-one replied; But I
spoke with Support and they couldn't figure it out either, so they have
reported it to Protel.

Steve

-----Original Message-----
From: Brian Guralnick [mailto:[EMAIL PROTECTED]]
Sent: 23 October 2001 07:37
To: Protel EDA Forum
Subject: [PEDA] Colors on print preview.


I'm having trouble changing the colors for some layers using the print
preview.  Are
there any tricks, or remedies?

____________
Brian Guralnick


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to