hello,

i just finished a board that had an connector with little smt-type
feet, some that contacted with the top, some that contacted with
the bottom of the board.  i played with getting a footprint with top 
and bottom pads, but it didn't seem to want to cooperate, so i 
ended up hacking it and splitting the connector into two separate 
connectors in the schematic and assigning separate footprints to 
them and merely displacing the bottom one to the bottom side on 
the pcb itself.

i've now got another board to do with the same type of connector,
only smaller, and i'd like to footprint the thing properly so that it
is only one connector and has top and bottom surface pads.

is this possible?  could someone give me a hint on how to do it.

thank you, miker 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to