At 12:27 PM 1/31/2002 -0800, JaMi Smith wrote: >Have you considered "tenting" your vias (covering them with solder >mask), which should eliminate the problem and bring it back into the >range of a standard clearance problem?
You can and should also set your clearance rules, together with your solder mask expansion, so that you have enough clearance. Design/Rules/Routing/Clearance Constraint, Add, Filter Kind / A: Object Kind / Vias, B: Object Kind / Smd Pads and/or Thru-Hole Pads. Likewise set the Manufacturing rule as you need for solder mask clearance. On tight SMT boards one might set Solder Mask clearance to 2 mils or even 0. This can be set for particular footprints differently than for the rest of the board. [EMAIL PROTECTED] Abdulrahman Lomax Easthampton, Massachusetts USA * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *