The configuration data is (automatically) stored in the [schematic-name].cfg file. If you use the ddb-system, the cfg file is saved in the same folder as the schematic. Do you use the windows file system ? Must be a problem with storing the cfg file in the same location as the schematic.
Rolf Molitor Ing.Buero i2e Remscheid / Germany -----Urspr�ngliche Nachricht----- Von: "Stephen Casey" <[EMAIL PROTECTED]> An: "Protel forum" <[EMAIL PROTECTED]> Gesendet: Donnerstag, 28. M�rz 2002 13:33 Betreff: [PEDA] Saving simulation setups > Hello all, > > I'm using the simulator in P99SE, SP6, and I can't get the simulation setup > to save. What I mean is, if I set it to do an ac small signal analysis, as > well as the transient analysis, then run the analysis, the first run through > has all the analyses as expected, but if I go back and run another > simulation, the ac has been disabled, and I only get the transient results. > I need to re-enable the ac analysis, and set the start and stop frequencies > every time. This is extremely irritating! > > Any help will be very gratefully received. > > Thanks for your time. > > Steve. > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
