[EMAIL PROTECTED] wrote: <SNIP> > 1. Drill bit manufacturers normally make tools with diameters
> in the range 0.3 - 6.5mm (0.012 - 0.256") in step of 0.05mm (0.02"). <SNIP> I believe that should be 0.05mm (0.002") If all I could get was 20mil increments I would be in a real predicament! David W. Gulley Destiny Designs * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
