At 09:03 AM 5/21/2002 +1000, you wrote:
>On 12:16 PM 20/05/2002 -0700, Embedded Matt said:
>>Two easy ones (I think):
>>
>>(1)
>>I have a multi-page schematic with ports to connect
>>nets between pages.  Is there any way, besides adding
>>a net label, to force Protel to give the net the port
>>name in the netlist instead of something like R54_1?
>
>No.
>
>
>>(2)
>>I am using the Reports/Add Port References (Flat)
>>feature which works pretty well except that it doesn't
>>seem to generate a reference for ports of the same
>>name on the same page.  Is there any way to get the
>>references for ports on the same page?
>
>There is a 3rd party port annotator available.
>http://www.aspiring-technology.com/
>
>This third part server has been reported by some to be better than the 
>in-built tool but I have not tested either so can't vouch for that.
>
>Ian Wilson
>

This is a very good tool. A lot better than Protel's attempt. I just hope 
Protel put's it in their upcoming release. Positioning could be better. 
Something for Protel to shoot for.


Rusty Garfield C. I. D.
Development Technician IV
Sugar Land Product Center
(281) 285-7611 (voice)
(281) 285-7619 (fax)
[EMAIL PROTECTED] (e-mail)

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to