Mike,

You might simply add the mating connector pair to the schematic, and run 
all required signals through both connectors. No net name changes needed. 
Everything else is done in pcb layout. You end up with one board design 
which is designed to break in two. You would wind up with some traces going 
right to the board edge (the lines between the 2 connector parts). To avoid 
this, delete these few trace segments after the board passes drc. Then you 
will get a few broken net errors.

Richard


Cheesecote Mountain CAMAC,  24 Halley Drive; Pomona, NY 10970
voice: 845 364 0211, fax: 845 362 6947,  www.cmcamac.com

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to