i assume you want to make electronic dwgs?
how about PDF ?

Dennis Saputelli

Richard Stevense wrote:
> 
> Hello all,
> 
> I am vainly attempting to create assembly drawings for my current project. I
> have found two methods for creating these drawings but with unsatisfactory
> results.
> 
> Method 1: Within Print Preview export the drawing (Top or Bottom
> Overlay/Mech 1 on) without Font Substitution and Non-Enhanced WMF. Open a
> new blank schematic sheet and place WMF graphic.
> Result: Weird looking part designators.
> 
> Method 2: Same as Method 1 but use Font Substitution (Verdana looks best in
> my opinion).
> Result: Beautiful looking part designators but some designators (not all)
> are in weird/rotated positions (not in the same places or orientation as
> original Print Preview document).
> 
> Anybody out there have a better method or found some way around this?
> 
> Start of gripe... Also, I find it odd that you can export in Enhanced WMF
> from Print Preview but you cannot place this file format in a schematic
> sheet. End of gripe...
> 
> Thanks in advance,
> Richard Stevense
> Calgary, Alberta.
> 


************************************************************************
* Tracking #: 26AFE1036A6F8643A9D85A989E28FB26291C2E6E
*
************************************************************************
-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to