> From: Christopher Rhomberg [mailto:accusync@;new.co.za]
> I am using Protel 99SE and cannot figure out why when I drop > a polygon plane, which I choose to be GND it drops the > plane over all the pads and tracks in the area. > I have my netlist correct, I think I have set the polygon > plane right by setting not to remove dead copper. I'd recommend you set it to remove the dead copper, though its not going to make a difference for your current problem. I would also select "pour over same net" and "lock primitives" > I still cannot get it working properly. > If I click on any of the tracks around there each one has > it's separate net name so why should the > polygon cover them. > This may be a stupid question, but is it possible you are not placing your polygon on the correct layer? Julian * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:proteledaforum@;techservinc.com * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:ForumAdministrator@;TechServInc.com * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@;techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
