Cmon Rene,
I didn't have time to write a book. Likewise one wouldn't typically
route 300volts at 4 mil tracks and spaces now would you? There are always
other confining requirements and regulations.
Sincerely,
Brad Velander.
Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel (604) 292-9089 (direct line)
Fax (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Check out our fall promotion at www.norsat.com. Limited quantities. Sale
ends December 24, 2002.
Contact your Account Manager or call 1-800-NII-4LNB or email
[EMAIL PROTECTED]
> -----Original Message-----
> From: Rene Tschaggelar [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, December 05, 2002 3:51 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] polygon plane clearance question
>
>
> Hmm,
> a 300 Volt track should perhaps have a bit more clearance
> than just 10mil. Set that under Design rules, clearances,
> there make a new one and do it for one or more specific nets.
>
>
> Rene
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
