HELP!

I thought I had followed all the rules, both from P99SEsp6 and the ones the distinguished members of this forum found out about the subject of splitting planes.......

In the PCB editor all looks fine: a VCC plane with several (non-nested) sub-planes and a GND plane with a PE sub-plane.
No vias at all in the 30 mil boundaries (took quite a bit of shuffeling).


In the print preview however the VCC plane appears without the sub-planes. Rebuild seems to have no effect whatsoever on this phenomenon.
The GND plane on the other hand shows the sub-plane just fine.....
Where have my VCC sub-planes gone?


Did I do something stupid?
Or is this another 'undocumented feature' (like the hole size) of the print preview process?


Please, enlighten me......

Leo Potjewijd
hardware designer
IE Keyprocessor bv.

[EMAIL PROTECTED]
+31 20 4620700



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to