What's affordable?

I recently had 5 boards assembled, about 7"x12", 300 components (2400 pads), passives on both sides, fine pitch on top, a few thru hole parts (to-220, idc, etc). Total cost for 5 boards about $2500 (incl $1200 nre). I doubt if these could have been hand assembled in much less than the 2 week turnaround.

Richard

At 02:13 PM 9/3/2003, you wrote:


Tom Reineking wrote:

Hi Yuriy,
We've had very good luck with quality and quick turn around with Advanced Circuits, www.4pcd.com. I haven't done much with price comparison, though. Good luck.

I was going to give the same information, but I think he is looking for assembly (stuffing) of the boards. If that is true, I'm not sure you can find any outfit that will do affordable work on only 10 pieces. The setup effort is just too great for such a small job. It probably makes more sense to buy the parts yourself, and find a part time person who can assemble it directly under the guidance of the person who designed it.

Jon



Cheesecote Mountain CAMAC, 24 Halley Drive; Pomona, NY 10970 voice: 845 364 0211, fax: 845 362 6947, www.cmcamac.com



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to