I am using DXP +SP2 and have a PCB design where the document size is very
much bigger than the board. Because of this I can't get a print preview or
generate Gerber files. In the latter case I get a 'film too small' error. I
don't know how the document size got changed but I would very much
appreciate a way to reset it to the same as the sheet so I can make some
output files. All suggestions welcome.

 

Regards,

 

Dave

 



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to